Assembly - Husqvarna 236R Operator's Manual

Safety instructions for maintenance
• If you cannot adjust the idle speed to make the
cutting attachment stop, speak to your service
WARNING: Read the safety chapter before
you assemble the product.
Introduction
WARNING: Before you assemble the
product, you must read and understand the
safety chapter.
WARNING: Remove the spark plug cable
from the spark plug before you assemble the
product.
To install the body of the product
• Attach the engine (A) to the tube (B) with 4 screws
(C).
A
B C
10
center. Do not use the product until the product is
correctly adjusted or repaired.

Assembly

To install the handlebar
1. Install the handlebar in the handlebar clamp on the
shaft.
2. Install the protective sleeve.
To connect the throttle cable and stop
switch wires
1. Remove the air filter cover.
1395 - 004 - 14.09.2020