Advertisement
GAMMA instabus
Technical Product Information
November 2014
Binary input device N 263E11
16x AC 12...230 V / DC 12...115 V
Attaching the bus terminal (Figure 3)
Insert the bus terminal into the guide slot and press
-
the bus terminal (D2) backwards until it reaches the
stop position.
Figure 3: Attaching / removing the bus terminal
Mounting the insulating cap
If the device is to be mounted on a DIN rail without a
-
data rail, then the contact system must be covered us-
ing the supplied insulating cap.
Removing the locating clamp (Figure 4)
The locating clamp (E3) encloses the contact system
-
(E2) on the rear of the device (E1).
Insert the screwdriver between the DIN rail mounted
-
device (E1) and the locating clamp (E3) and remove
the clamp.
Clipping on the insulating cap (Figure 4)
Place the insulating cap (E4) on the contact system and
-
press so that it snaps into place.
E3
E1
E2
Figure 4: Covering the contact system
Technical Manual
Update: http://www.siemens.de/gamma-td
2.7.4.1/4
D
2
D2.3
D2
D2.1 D2.2
D2
D2.4
D1
5 mm
D2
D2.4
E1
E2
E4
N 263E11, 4 pages
ã Siemens AG 2014
Subject to change without further notice
Dimension drawing
Dimensions in mm.
b
b = 6 module units
1 module unit (MU) = 18 mm
General notes
The operating instructions must be handed over to the
·
client.
Any faulty device is to be sent together with a return de-
·
livery note of the local Siemens office.
If you have further questions concerning the product
·
please contact our technical support.
Technical Support
+49 (911) 895-7222
'
+49 (911) 895-7223
7
*
support.automation@siemens.com
www.siemens.de/automation/support-request
*
P.O. Box 10 09 53, D-93009 Regensburg
5WG1 263-1EB11
44
55
Siemens AG
Building Technologies
Control Products and Systems
Advertisement
