Advertisement
Quick Links
Hardstop Kit
for Multi-Pro
Model No. 114–9577
Safety
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area of
potential danger. Replace any decal that is damaged or lost.
114-9576
1. Pinch point, hand—keep hand away from hinge.
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Turf Sprayers and Workman
Register at www.Toro.com.
Form No. 3360-408 Rev A
®
200 Spray System
Installation Instructions
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Advertisement
Related Manuals for Toro 114-9577
Summary of Contents for Toro 114-9577
- Page 1 Replace any decal that is damaged or lost. 114-9576 1. Pinch point, hand—keep hand away from hinge. Register at www.Toro.com. © 2008—The Toro® Company Original Instructions (EN) 8111 Lyndale Avenue South Printed in the USA. Bloomington, MN 55420...
- Page 2 Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. – No parts required Drill the boom. Bracket Bumper Bolt (5/8 x 5 inches) Nut (5/8 inch) Install the stops.
- Page 3 Drilling the Boom Installing the Stops No Parts Required Parts needed for this procedure: Bracket Procedure Bumper 1. Measure and mark the holes shown in Figure 1. Bolt (5/8 x 5 inches) Use the flat edges of the boom for the measurements. Nut (5/8 inch) When all holes are marked, use the bracket Bolt (5/16 x 1 inch)
- Page 4 Figure 3 Right side shown 1. Center boom asssemlby 4. nuts (5/16 inch) 2. Assembled bracket and 5. Decal bumper 3. Bolt (5/16 x 1 inch) 3. Install a decal 114-9576 as shown in Figure 3. Adjusting the Booms to Level No Parts Required Procedure 1.