Replacing Drain Hoses; Removing Drain Hoses - Bosch SHEM63W55N Repair Manual

Repair

6.27 Replacing drain hoses

The drain hose (1) and sump hose (2) enter the water inlet control at the left rear of the
dishwasher.
Fig. 99: Drain hose connections at water inlet control

6.27.1 Removing drain hoses

Required tools:
Phillips screwdriver PH2
Slotted screwdriver Blade 4 mm x 0.8 mm x 100 mm, only
China
The hose is locked into the base below the water inlet control, so the
control has to be removed to remove the hose.
Prerequisite:
Dishwasher disconnected and pulled out→ Page 76
Water inlet control removed→ Page 117
2020-04-24_58300000218396_ara_en_c
1. Disconnect drain hose from customer drain line.
2. Disconnect water inlet tube from water inlet control.
3. Push the drain hose in to unlock it from the base to disconnect it (at the water inlet
control). For installation, slide the hose notch into the base.
[00342443]
4. Remove the valve and holder from the base just enough so the hose can slide out
(i.e. don't remove the water inlet valve completely).
Copyright by BSH Hausgeräte GmbH Page 117 of 126