Replacing Sump Parts (Inside Tub) - Bosch SHEM63W55N Repair Manual
Hide thumbs
Also See for SHEM63W55N:
- Installation instructions manual (88 pages) ,
- Operating instructions manual (88 pages) ,
- Quick start and safety manual (7 pages)
Table of Contents
Advertisement
Repair
6.25 Replacing sump parts (inside tub)
Required tools:
Slotted screwdriver
Blade 4 mm x 0.8 mm x 100 mm, only
China
The inside of the sump is easily accessed for maintenance, for removing the drain
pump cover and suction cap ("heat pump cover") for cleaning drain / heat pump im-
pellers.
Fig. 97: Sump location
Prerequisite:
Door opened and all racks removed.
1. Lift out lower spray arm.
2020-04-24_58300000218396_ara_en_c
2. Unscrew microfilter counterclockwise (ccw) and lift out microfilter and fine filter
screen.
[00342443]
3. Remove (pull out) fill tube.
4. Carefully pry out drain pump cover (2, below).
Removing the aqua sensor (1, above) is only necessary when replacing the
sump.
5. Carefully pry out suction cap (3, above).
Copyright by BSH Hausgeräte GmbH
Page 112 of 126
- Quick Links:
- Fault Diagnosis
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SHEM63W55N and is the answer not in the manual?
Questions and answers
What is error code f09
Error code E:09 on the Bosch dishwasher model SHEM63W55N indicates a faulty heater circuit (open-circuited). Troubleshooting steps include:
1. Check the harness between the heat pump heater and the power module. Replace if faulty.
2. Measure the heat pump heater resistance:
- If the resistance is correct, replace the power module.
- If the resistance is incorrect, replace the heat pump.
This answer is automatically generated
The rear height adjuster foot and white gear with collar, have loosened and separated from the worm gear inside. How to reinsert whit gear and start foot into it? Drawings or instructions would help, details not found on Page 124 in repair manual. Help needed. thanks