Dual DMA3100 Installation & Owner's Manual

Dual DMA3100 Installation & Owner's Manual

Marine power amplifiers

Advertisement

Quick Links

DMA3100
DMA4100BT
MARINE POWER AMPLIFIERS
INSTALLATION / OWNER'S MANUAL
IP66 Rated
(DMA4100BT)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DMA3100 and is the answer not in the manual?

Questions and answers

Summary of Contents for Dual DMA3100

  • Page 1 DMA3100 DMA4100BT MARINE POWER AMPLIFIERS INSTALLATION / OWNER'S MANUAL IP66 Rated (DMA4100BT)
  • Page 2 INSTALLATION Preparation Amplifier Features Before You Start Mounting Location TYPICAL MOUNTING METHOD...
  • Page 3: Connection Descriptions

    INSTALLATION Connection Descriptions NOTE: Be sure to follow specific instructions included with your amplifier installation kit (not included with this amplifier). The information below should be used as a general guideline only. Power Wire (+12V) Ground Wire (GND) Remote Turn-on Wire (REM) Speaker Wires Input Signal CAUTION...
  • Page 4: Audio Inputs

    INSTALLATION Audio Inputs DMA3100 DMA4100BT...
  • Page 5: Amplifier Controls

    INSTALLATION Amplifier Controls DMA3100 DMA4100BT...
  • Page 6: Power And Speaker Connections

    INSTALLATION Power and Speaker Connections DMA3100 DMA4100BT...
  • Page 7: Typical Wire Routing

    Front L White +, - 2-8 ohms SPEAKERS Rear R Violet +, - RF remote control(IPX7) RF remote receiver (DMA4100BT) Rear L Green +,- REM (Remote Turn On) Main Power Connections Fuse Rating Power/Ground Wire Size DMA3100 DMA3100 DMA4100BT DMA4100BT...
  • Page 8: Amplifier Connections

    INSTALLATION Amplifier Connections 4 Speakers (stereo) Speakers (bridged) Speaker Connections Typical Stereo Wiring Typical Bridged Wiring (2 ohms minimum) (4 ohms only) Input Signal Connections Low Level Input (RCA)
  • Page 9 INSTALLATION Configuration/Setup Input level Control Hi-Pass Frequency Control LED Indicators (at the top panel POWER of amplifier) PROTECTION) *Note :...
  • Page 10: Pairing A Device

    INSTALLATION Bluetooth Operation (DMA4100BT) Pairing a Device Preparation Pairing a New Device The device name is "NA300BT ” Streaming Audio Operation Note before you use Bluetooth: 1. Once your device has been paired to the DMA4100BT, it will remain paired until the power is turned off, to stream audio the phone or device must be manually connected to the Bluetooth on the amplifier.

This manual is also suitable for:

Dma4100bt

Table of Contents