Installation Of The Product - Husqvarna AUTOMOWER 420 Operator's Manual

3.5 Installation of the product

3.5.1 Installation tools
• Hammer/plastic mallet: To simplify putting the
stakes into the ground.
• Edge cutter/straight spade: To bury the boundary
wire.
• Combination pliers: For cutting the boundary wire
and pressing the connectors together.
• Adjustable plier: For pressing the couplers
together.
3.5.2 To install the charging station
CAUTION:
the charging station plate.
CAUTION:
baseplate of the charging station.
WARNING:
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
1201 - 007 - 20.02.2023
D
A
B
C
Do not make new holes in
Do not put your feet on the
Make sure that the plugs of
When connecting the power supply, only use a power
outlet that is connected to an residual-current (RCD)
device.
1. Read and understand the instructions about the
charging station. Refer to
the charging station on page 14 .
2. Put the charging station in the selected area.
Note:
Do not attach the charging station to the
ground with the screws until the guide wire is
installed. Refer to
20 .
3. Connect the low-voltage cable to the charging
station.
4. Put the power supply at a minimum height of 30
cm / 12 in.
min 30 cm / 12"
5. Connect the power supply cable to a 100-240V
power outlet.
Note:
The product can be put in the charging
station to charge while you install the boundary
wire and the guide wire.
6. Put the low-voltage cable in the ground with stakes
or bury the cable. Refer to
position with stakes on page 20 or To bury the
boundary wire or the guide wire on page 21 .
7. Connect the wires to the charging station after
the installation of boundary wire and guide wire is
complete. Refer to
page 19 and To install the boundary wire on page
19 .
8. Attach the charging station to the ground with the
supplied screws after the guide wire is installed.
To install the guide wire on page 20 .
Refer to
3.5.3 To install the boundary wire
CAUTION:
a coil. The coil causes interference with the
product.
1. Put the boundary wire around all of the work
area. Start and complete the installation behind the
charging station.
To examine where to put
To install the guide wire on page
To put the wire into
To install the boundary wire on
Do not put remaining wire in
Installation - 19