Sharp 61U-WP7H Service Manual page 19

2-7. Remove the four screws from the bottom of the
screen frame. Put your hand in between the bottom
center of the screen frame and the cabinet. Pull out
the frame.
2-8. The angles are secured on the cabinet. The CRT
unit's aluminum diecast section is fixed on these
angles. To detach each CRT unit, remove the four
screws near the posts at the aluminum die cast
section and then pull out the unit upward.
3. Detaching the mirror
(Initial setup)
» Detach the screen and you will find the mirror secured by
wooden fixtures at top and bottom as well as both sides.
The top fixture alone is screwed down, whereas the
other three fixtures are locked with adhesive and cannot
be removed.
» The top and side fixtures have grooves in which the
mirror is fitted. The bottom fixture has no groove and the
mirror is placed just on it.
3-1. Remove the four screws from the top fixture and
detach this fixture.
3-2. Hold both ends of the mirror and gradually lift the
mirror along the grooves of the side fixtures. Once out
of the grooves, pull the mirror toward yourself.
2-8
CRT Unit
Top View
RED
2-8
19
GREEN BLUE
3-1
Mirror
3-2 3-2
61U-WP7H
55U-WP7H
2-7