User Manual Acrobat WB-2 V4.2 1 Safety Information Explanations of Symbols The following tables are used to indicate hazards and provide cautionary information in relation to the handling and use of the equipment. 1.1.1 Danger Danger Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
User Manual Acrobat WB-2 V4.2 Service All service has to be undertaken ONLY by qualified service personnel. • All service has to be undertaken ONLY by qualified Riedel service personnel. • • There are no user serviceable parts inside the device.
User Manual Acrobat WB-2 V4.2 Battery Safety The device is fitted with the following battery: Lithium-Ion battery Acrobat RB-2300, 7.2V, 2300mAh. Use only the original Lithium-Ion battery. Warning Risk of explosion if battery is replaced by any other incorrect type...
This manual describes the user accessible elements of the Acrobat Wireless Beltpack 2 (WB-2). Where not other stated, all descriptions apply to Acrobat CC-8, CC-60 and CC-120. For further information about the Acrobat hardware please contact your local distributor or the Riedel headquarters in Wuppertal.
User Manual Acrobat WB-2 V4.2 3 User Elements User Elements Top Error LED Channel A Display Channel B Power LED Battery Channel Knob A CALL Key Call LED SCALL Key Channel Knob B Volume A / Talk A Volume B / Talk B...
User Manual Acrobat WB-2 V4.2 3.1.1 Error LED (red) The error LED indicates that the Beltpack is outside the DECT coverage area. The partyline cannot be used in this case. Color Status Red, flashing fast (0.5 sec ON, 0.5 sec OFF)
User Manual Acrobat WB-2 V4.2 3.1.5 Display 3.1.5.1 Display elements during operation mode Signal (RF) CA-6 No. Microphone Battery strength (RPN) type capacity FN Key 1 Partyline Partyline FN Key 2 CHAN_A CHAN_B Figure 2: Display elements during operation mode...
Page 11
User Manual Acrobat WB-2 V4.2 3.1.5.2 Display elements during metering mode If metering mode is activated (see Service Menu), the display shows the following elements. Signal (RF) CA-6 No. Microphone Battery strength (RPN) type capacity RSSI Value Figure 3: Display elements during metering mode The following table depicts the correlation between "RSSI Value"...
Page 12
User Manual Acrobat WB-2 V4.2 3.1.5.3 Other display messages (excerpt) Display Comment Power-On: Beltpack is loading the bootloader (boot1) Bootloader 1 Power-On: Beltpack is booting the bootloader (boot2) Booting 2 Power-On: Beltpack is booting the Application Booting Applic During firmware updates or after changes in the service menu: Beltpack is...
User Manual Acrobat WB-2 V4.2 3.1.6 Channel Knob (dual purpose) 3.1.6.1 Volume Channel A/B The channel volume knob levels the volume of the respective channel of the WB-2 (0-100%). Turn the knob clockwise to increase and counterclockwise to decrease the volume of the channel.
User Manual Acrobat WB-2 V4.2 User Elements Bottom --> On Headset Connector Ethernet DIP Switch Power Switch (4-pin, mono) Connector Figure 5: User Elements Bottom (without bottom protective cover) 3.2.1 Power switch The WB-2 may be switched OFF or ON using the Power switch.
User Manual Acrobat WB-2 V4.2 3.2.3 Ethernet Connector For firmware updates and initial configuration the WB-2 has to be connected with the Cell Controller using the Ethernet connector (RJ45, 10/100 Mbit with auto negotiation). Signal Figure 7: Ethernet Connector RJ-45 (8P8C) 3.2.4...
User Manual Acrobat WB-2 V4.2 4 Service menu Besides the normal operation mode of the WB-2, a special service mode consisting of a service menu is available. If the WB-2 is in service mode, the following restrictions apply: The display of the operation mode is not available, instead the service menu will be displayed.
User Manual Acrobat WB-2 V4.2 Operation of service menu 4.2.1 User elements (Navigation keys) In service mode, the User elements of the WB-2 have other functionality than in normal operation mode. Function Function Function Function "Escape" "Up" / Decrease (-) "Down"...
Page 18
User Manual Acrobat WB-2 V4.2 4.2.2.1 Initial screen After stepping into the service menu, selection mode is active and the first entry in the main menu is selected (and therefore marked inverse). Display Comment Menu display after invoking menu. Wireless The ">"...
User Manual Acrobat WB-2 V4.2 4.2.2.5 Exiting service menu To exit the edit mode or exit the menu to the upper menu level - or if already in the main menu level - exit the service menu completely - use the [Escape] button once or consecutively.
Page 20
User Manual Acrobat WB-2 V4.2 4.3.2.2 Selection of a MADI Channel After invoking the menu MADI/Profile, the list of free MADI channels will be downloaded by air from the CC-60 / CC-120. Free MADI channels are Channels which are Enabled and no Outgoing call is assigned.
User Manual Acrobat WB-2 V4.2 5 Tones and events Tones To signal the user special events, some signal tones are generated at the WB-2. Tone name Tone type (*) Description Low battery 0.1 / 60.0 / 400 Low battery tone - the battery of the WB-2 is near its end (only some minutes left).
User Manual Acrobat WB-2 V4.2 Maintenance Recommendations Following points are strongly recommended to prevent malfunction of the system. General None Daily None Weekly None Monthly None Yearly Check the capacity of the battery and replace it if necessary. • Other...
• Your primary point of contact for any service issues is your local dealer. In addition, Riedel Customer Service in Wuppertal, Germany is also available to assist you. Telephone: +49 (0) 202 292 9400 (Monday - Friday, 8am – 5pm, Central European Time) Fax: +49 (0) 202 292 9419 Skype: riedel.communications.service...
Need help?
Do you have a question about the Acrobat WB-2 and is the answer not in the manual?
Questions and answers