Husqvarna AUTOMOWER 320 NERA Operator's Manual page 34

Message
Electronic problem
Loop sensor problem
Tilt sensor problem
Invalid sub-device
combination
STOP button prob-
lem
Connectivity problem
Safety function faulty
Invalid system config-
uration
Lift sensor problem
Collision sensor
problem
Radar problem
Temporary battery
problem
Battery problem
Empty battery
Battery needs re-
placement
Battery near end of
life
34 - Troubleshooting
Cause
Temporary electronic or firmware problem in
the product.
Temporary battery or firmware problem in the
product.
Incorrect type of battery.
The product cannot find the charging station.
The battery is at the end of its life cycle.
The product cannot enter the charging sta-
tion because the antenna in the baseplate of
the charging station is damaged.
The product is in the charging station, but
does not charge the battery.
The battery state of health is low.
The battery state of health is critically low.
Action
Restart the product.
If the problem stays, speak to your approved
servicing dealer.
Restart the product. If the problem stays,
speak to your approved servicing dealer.
Use only original batteries recommended by
the manufacturer.
Change the position of the guide wire. Refer
To install the guide wire on page 18 .
to
Do a check of the installation settings about
how to find the charging station. Refer to
find the charging station on page 21 .
Speak to your authorized service center to
replace the battery.
If the indicator lamp on the charging station
flashes red, the antenna is damaged. Speak
to your authorized service center.
Make sure that the charging plates on the
product and the contact plates on the charg-
ing station are in contact. Clean the contact
plates and charging plates.
Replace the battery. Speak to your author-
ized service center.
Replace the battery. Speak to your author-
ized service center.
2071 - 001 - 29.03.2023
To