Husqvarna AUTOMOWER 320 NERA Operator's Manual page 12

• Keep a minimum of 150 cm / 60 in. of free space
to the right and left of the center of the charging
station.
• Put the charging station near a power outlet.
• Put the charging station on a level surface.
• The baseplate of the charging station must not be
bent.
max. 5 cm / 2"
max. 5 cm / 2"
• If the work area has two parts separated with a
steep slope, we recommend to put the charging
station in the lower section.
• Put the charging station in an area with protection
from the sun.
®
• For Automower 320 NERA, put the charging
station where there is Wi-Fi coverage to download
new firmware. Refer to
the air FOTA (Firmware over the air) on page
24 . For Automower
recommended, but not necessary.
• If the charging station is installed on an island,
make sure to connect the guide wire to the island.
12 - Installation
Download firmware over
®
430X/450X NERA this is
3.4.2 To examine where to put the power
supply
CAUTION:
on the product do not cut the low-voltage
cable.
CAUTION:
cable in a coil or below the charging station
plate. The coil causes interference with the
signal from the charging station.
• Put the power supply in an area with a roof and
protection from the sun and rain.
• Put the power supply in an area with good airflow.
• Use a residual-current device (RCD) with a tripping
current of maximum 30 mA when you connect the
power supply to the power outlet.
Low-voltage cables of different lengths are available as
accessories.
3.4.3 To examine where to put the
boundary wire
CAUTION:
minimum 15 cm / 6 in. in height between
the boundary wire and water bodies, slopes,
precipices or public roads. This will prevent
damage to the product.
CAUTION:
operate on gravel.
CAUTION:
when you install the boundary wire.
CAUTION:
without noise, isolate all obstacles such as
trees, roots and stones.
The boundary wire should be put as a loop around the
work area. Sensors in the product senses when the
product approaches the boundary wire, and the product
selects another direction. All parts of the work area must
be maximum 35 m / 115 ft. from the boundary wire.
Make sure that the blades
Do not put the low-voltage
There must be a barrier of
Do not let the product
Do not make sharp bends
For careful operation
2071 - 001 - 29.03.2023