– Remove screws -1-.
– Remove the screw -2- and remove the power steering pump
-3-.
Installing
Install in reverse order of removal. Note the following:
Note
Clean oiled places in engine compartment.
♦
Always replace seals.
♦
Before installing new pump on intake side, fill hydraulic oil and
♦
screw in by hand until oil escapes on pressure side.
♦
Charge air system hose supports and hoses must be free of
oil and grease before installation.
Secure all hose connections with hose clamps appropriate to
♦
the model, refer to the Parts Catalog.
– Turn the hub by hand until oil runs out of the pressure side.
– To assist attachment of vane pump, drive threaded sleeve for
rear bolt back slightly in bracket.
– Install the power steering pump.
– Tighten the front screws.
– Tighten the rear screws.
– Screw belt pulley onto vane pump.
– Secure the intake hose. Note location of suction hose on pow‐
er steering pump.
– Use a new seal, refer to -Item 8-
-Item 10-
⇒ Item 10 (page 329)
– Tighten the pressure line threaded connector.
Tightening Specifications: Power Steering Pump for Engine, Gen‐
eration I, without SCR, refer to
Tightening Specifications: Power Steering Pump for Engine Gen‐
eration I with SCR and Generation II
– Clean oiled places in engine compartment.
– Install ribbed belt and check alignment of ribbed belt, refer to
⇒ Rep. Gr. 13 .
– Top off Hydraulic Oil .
– Check power steering fluid level, refer to
⇒ "4.1 Power Steering, Checking Hydraulic Oil Level",
page 310
.
– Bleed steering system, refer to
⇒ "4.2 Steering System, Bleeding after Replacing",
page 311
.
Suspension, Wheels, Steering - Edition 01.2014
⇒ Item 8 (page 327)
.
⇒ page 326
⇒ page 328
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
or o-ring
5. Power Steering Pump, Hydraulic Pipes and Reservoir
Audi Q7 2007 ➤
333
Need help?
Do you have a question about the Q7 2007 and is the answer not in the manual?
Questions and answers