Servotronic Solenoid Valve N119 , Removing And Installing - Audi Q7 2007 Repair Manual

Steering Gear without Steering Arm Thrust Ring
– Measure dimension -a- as shown in illustration.
Dimension -a- must be 152.6 mm.
Note
If dimension -a- is not achieved, check whether version is same
on left and right.
– Remove right boot from steering gear.
– Turn steering toward left as far as stop.
– Measure the dimension between the steering gear and the tie
rod/steering arm thrust ring hex fitting.
Dimension -a- must be the same in both measurements.
3.6 Servotronic Solenoid Valve - N119- ,
Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
♦ Steering Gear Grease
Removing
Request values with -Vehicle Diagnostic Tester- , refer to
-Item 17- ⇒ Item 17 (page 300)
– With vehicles with air suspension, place vehicle on hoist, refer
to ⇒ "4 Positioning Vehicle on Hoist and Wheels", page 10
– Only remove front noise insulation -1-.
Suspension, Wheels, Steering - Edition 01.2014
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q7 2007 ➤
.
303
3. Steering Gear