Panasonic Toughbook CF-U1A1B1G2M Reference Manual page 61

Barcode Configuration Utility
Barcode Software Tool
Barcode Software Tool is for Barcode Key Emulator.
Emulator Prefix
1
Click [Barcode Software Tool].
2
Click [Configure] on the right of [Emulator Prefix].
The subsequent setting procedure is the same as the one for [Barcode Reader Prefix] in [Data Configuration]
( page 59).
Note: There isn't a limitation of number of characters such as with 1D Barcode Reader.
Emulator Suffix
1
Click [Barcode Software Tool].
2
Click [Configure] on the right of [Emulator Suffix].
The subsequent setting procedure is the same as the one for [Barcode Reader Suffix] in [Data Configuration]
( page 59).
Note: There isn't a limitation of number of characters such as with the 1D Barcode Reader.
Allow un-readable characters
This allows the user to restrict or allow all ASCII characters.
When the check mark is checked, all ASCII values (except HEX 00)
are part of the barcode scanned data. If you remove the check mark
from (A), all ASCII characters of a HEX value of 1F or less are
removed from the barcode scanned data.
Show AIM
If you add a check mark for (B), AIM Identification is showed at the
beginning of the scanned barcode data.
This can only be enabled if [AIM Symbology] is enabled in the [Data
Configuration] ( page 59).
A
B
61
C
D