Call Progress Tones; Caller Id - Panasonic DBS-576HD Technical Manual

Chapter 3. System Features

Call Progress Tones

Description
The System supplies a full array of call progress tones. These tones provide audible indications of the
status of calls and include dial tone, busy tone, ringback tone, error tone, confirmation tone, and
splash tone. The complete specification for these tones may be found in Section 300 - Installation.
In addition to call progress tones, Direct Station Select (DSS) LEDs and the display provide
additional indication of the status of calls.
Hardware Requirements
• N/A
Related Programming
• N/A
Considerations
• N/A

Caller ID

Description
A properly equipped system supports Caller ID, a service offered by the network telephone service
provider. The CO sends calling number information to the system after the first ring. Users with
display telephones can see Caller ID information as incoming calls ring at their extension. They can
also access previous calls via the Caller ID Call Log feature. The Caller ID number is recorded in
SMDR.
With Version 5.0, the caller name (if available) can be displayed for a calls received from an
ISDN PRI line (ISDN / PRI NI II standard only).
Hardware Requirements
• Loop-start trunk card (8) (VB-44510) with Caller ID circuit card (8) (VB-44513), Loop-start
trunk card (4) (VB-44514) with Caller ID circuit card (4) (VB-44515), ISDN (PRI = VB-44540,
BRI = VB-44530).
Related Programming
• FF2-0: Caller ID
• FF2-0: Caller ID Ring Control
• FF3-0: Call Duration Display
• FF1-0-01: Alpha Tagging (Name/No. Display)
Considerations
• ISDN (PRI/BRI - T Point) can get calling party information.
• Caller ID service must be ordered from the local telephone operating company or the
interexchange carrier.
3-10 DBS 576 (USA) issued September 2001
Section 700 - Operation
576-50-700