Section 700 - Operation
Operation
To answer calls using the Headset Operation:
Note: If Headset mode is already on, the following procedure turns it off. If Headset mode is off,
this procedure turns it on.
1. Pick up the handset or press the ON/OFF key.
2. Press the PROG key.
3. Enter 90 for Headset mode.
4. Replace the handset or press the ON/OFF key.
Hardware Requirements
•
A headset must be installed.
Related Programming
•
FF1-0-3: Extension COS (Dial Tone Stop)
•
FF1-2: Dial Plan
•
FF3: Extension COS
Considerations
•
Intercom Dial Tone is enabled/disabled regardless of Headset mode (per programming for the
Extension Class of Service [COS])
Hot Dial Pad
Description
The dial pad on digital key phones can be designated as "hot" on an extension-by-extension basis.
The Hot Dial Pad allows the user to initiate a call without going offhook. Extensions with the Hot
Dial Pad enabled can initiate calls by pressing any of the numeric keys
keys.
The Dial Pad can be hot under these conditions:
•
When the extension is idle
•
When the extension is holding a call
•
When the extension is receiving a page.
The Dial Pad cannot be hot under these conditions:
•
When a call is ringing at the extension (intercom or CO)
•
When the extension is on a call.
576-50-700
Action
DBS 576 (USA) issued September 2001
Chapter 5. Key Telephone Features
Result
Intercom dial tone
(0-9), and the "*" and "#"
5-55