Table of Contents
Advertisement
• There could also be a problem with the USB cable. Replace the USB cable and retry the printing.
If you use the printer over a LAN, make sure the printer is correctly set up for network use.
Make sure MP Drivers are installed correctly.
Check 3
Refer to
Updating the Driver
When printer is connected to your computer with a USB cable, check device
Check 4
status from your computer.
Follow the procedure below to check the device status.
1. Select Control Panel > Hardware and Sound > Device Manager.
1.
Note
• If the User Account Control screen is displayed, select Yes.
2. Open USB Printing Support Properties.
2.
Double-click Universal Serial Bus controllers and USB Printing Support.
Note
•
• If the USB Printing Support Properties screen is not displayed, make sure the printer is
correctly connected to the computer.
Check 2
3.
3. Click General tab and check for a device problem.
If a device error is shown, see Windows Help to resolve it.
Other Error Messages (Windows)
If an error message is displayed somewhere other than printer status monitor,
Check
check the following:
• "Could not spool successfully due to insufficient disk space"
•
Delete any unnecessary files to increase the amount of free space on the disk.
•
• "Could not spool successfully due to insufficient memory"
Close other applications to increase the available memory.
If you still cannot print, restart your computer and retry the printing.
• "Printer driver could not be found"
•
Refer to
Updating the Driver
• "Could not print Application name - File name"
•
Try printing again once the current job is complete.
to uninstall unnecessary drivers and install the latest drivers.
Make sure printer is properly connected to computer.
to uninstall unnecessary drivers and install the latest drivers.
440
Advertisement
Table of Contents
Need help?
Do you have a question about the PIXMA G3070 Series and is the answer not in the manual?
Questions and answers
how do I scan a document
To scan a document using the Canon PIXMA G3070 Series, follow these steps:
1. Placing the Document:
- Open the document cover.
- Place the document with the side to scan facing the platen (glass surface).
- Align the document with the alignment mark on the platen.
- Close the document cover gently, ensuring it stays closed during scanning.
2. Using the Document Feeder (if applicable):
- Load the document with the side to scan facing up in the document tray.
- Insert the document until it stops.
- Adjust the document guide to match the width of the document, but do not slide it too tightly.
3. Duplex Scanning (if applicable):
- For duplex documents, place the front sides facing up in the document tray.
4. Important Notes:
- Ensure that portions of the document near the edges (approximately 0.1 inches) are not over the scanning area, as they may not be scanned.
Once the document is properly placed, use the scanning feature via the printer's display panel or the associated scanning software on your computer to start the scan.
This answer is automatically generated
How do I keep the printer from going into sleep mode
can I copy a 4x6 photo on 3270 printer?
I have a Canon 3070 printer. I just refilled the black ink cell for the first time but it will still not print the characters in black, just the other colors on the page. The manual says to fill the well to the upper limit, but I do not have enough black ink, only about 2/3 of well, Do I need to get more ink to fill to the upper limit or is there a way to compensate for this problem?