Exterior Specifications; Warranty Information - Mitsubishi Electric DT125TXA User Manual

◆ Exterior Specifications

（DT128TXA Front face）（DT125TXA Front face）（Side face）

◆ Warranty Information

Users are requested to read the following warranty information with care.
Charge-Free Warranty Period and Scope
In the event of a product failure or flaw (hereafter referred to together as "failure") which
occurs during the charge-free warranty period, and which is the responsibility of
Mitsubishi, the product shall be repaired or replaced without charge by way of the outlet
where it was purchased, or through the services of a Mitsubishi regional/branch office.
However, in cases where a service person must be dispatched to a remote area to perform
repairs, the customer shall pay the dispatching cost.
■Charge-Free Warranty Period
The charge-free warranty period shall extend for one year from either the date of purchase or
delivery (to specified location). However, because a distribution period of up to six months is
possible after the product has been shipped, the charge-free warranty period shall extend for
no longer than 18 months from the manufacture date. Moreover, the charge-free warranty
period for repaired items shall not exceed the original warranty period (warranty period which
applied prior to the repair).
■Charge-Free Warranty Scope
(1) The product's charge-free warranty applies only to cases in which the product has been
used in the manner and in the environment prescribed in the operation manual, with all the
conditions and cautionary items indicated on the product's caution labels having been
observed.
(2) The following cases shall be considered as outside the scope of the charge-free
warranty, even if they occur during the warranty period.
1) Product failure caused by the customer (improper storage, handling, carelessness,
negligence, etc.).
2) Product failure resulting from the customer's unauthorized attempts to repair or
modify the product.
3) Product failure caused by using the product in a manner for which it was not
intended, or in a manner which exceeds industry norms.
4) Product failures which could have been prevented had the customer properly
maintained or replaced the cables, accessories, or equipment indicated in the
operation manual, etc.
5) Product failure due to a condition which could not have been anticipated within the
Figure 6.1 External dimensions
- 6 -
[mm]