Table of Contents
Advertisement
2. Then, copy
usb1:<configuration file>startup-config
Example:
localhost> enable
l
locathot> copy usbl
l
3. Type
to activate the new configuration.
reload
This causes the switch to reboot.
4. When prompted, System configuration has been modified. Save?,
type
.
no
5. When prompted, Proceed with reload?, press enter.
6. The switch reboots and you will see a set of reboot messages. It takes about
one minute for the switch to reboot. It returns to the login: prompt if
successful.
7. Check the group of four LEDs on the front of the switch. All four of the LEDS
should be solid green.
Note
Now we will configure a Mgmt IP for each switch.
8. Login to the switch again , this time the password is Scaleio123
9. Type
and click enter.
enable
10. Type
terminal (or
configure
11. Type
interface management 0
virtual interface which accesses management port 1 on the currently active
supervisor.
12. Type
, followed by the desired address, to assign a virtual IP
ip address
address for access to the active management port.
Example, this command assigns the IP address 10.0.2.5 to management port 0:
switch(config-if-Ma0)#ip address 10.0.2.5/24
l
13. Type
twice at the interface configuration and global configuration prompts
end
to return to Privileged EXEC mode.
14. Type
(or copy running-config startup-config) to save the new
write
configuration to the startup-config file.
15. Disconnect the service laptop from the console port IOIO.
Note
Arista switches are by default set to Use Jumbo Frames; no additional
configuration is needed on switches for Performance Best Practice.
16. Repeat this procedure if required to configure additional data switches.
) to enter global configuration mode.
config
to enter interface configuration mode for the
Configure the data switch
Equipment Installation
.
41
Advertisement
Table of Contents
