PAX A77 - Smart Mini Pos Terminal Quick Setup Guide

Also See for A77:

Table of Contents

Contents Checklist

Note: Product images shown may be different than actual product recieved.

Please check the components after unpacking. If any of the components are missing, please contact the dealer.

Contents	Qty.
A77 Smart Mini Payment Terminal	1
AC Power Adapter	1
USB Cable	1
Battery	1
Quick Setup Guide	1

Product Description - Part 1
Product Description - Part 2
Note:Product images shown may be different than actual product recieved.

POWER ON:
Press and hold the power button down for 3-5 seconds and then release.

POWER OFF:
Press and hold the power button down for 3 to 5 seconds and then release.

Do not use or place the battery in direct sunlight and/or smokey, dusty environments.
Do not strike, squeeze, and/or tread on battery.
Do not throw the battery in any liquids or place in/near fires.
If the battery is deformed or damaged, please stop using immediately and replace it.
If the continuous working time is only half of a new battery, the battery life may be at its end. Please replace it.
The specified battery model and charger must be used, otherwise there may be an explosion.

The charging time cannot exceed 24 hours. If the battery is out of power, please recharge in an appropriate time and then disconnect the device. Avoid damaging the battery with over-charge and over-discharge.
Please recharge the battery at least once every 6 months to avoid shortening its life.
Replace battery every two years.
Be sure to follow the instructions to dispose of wasted batteries.

Magnetic Stripe Card: Slide the card through the card reader slot from left to right or from right to left with the magnetic strip oriented towards the body of the device. Make sure that the card is fully inserted into the card reader while swiping the card.
Smart Card Reader: Insert the card fully into the reader with the metallic contacts facing up and towards the device. Make sure that the card is fully inserted into the card reader while scanning the card.
Contactless Card Reader: The contactless card reader reads cards and devices placed roughly within an inch (2.5 mm). For best results, place as close to the reader as possible and center the card over the indicated area.

Working Environment

Do not use industrial strength or abrasive cleaner as it may damage or scratch the screen.
Do not immerse the device in water or liquid.
Do not spray water or cleaner into EMV Card Reader or ports.
To clean the screen, apply distilled water or mild glass cleaner onto a soft, lint-free cloth and gently wipe terminal.

If any cables become damaged, seek a replacement.
Do not insert unknown materials into any port on the A77; this may cause serious damage.
If repairs are required, please contact a professional technician instead of attempting them on your own.
Avoid exposing the device to an excessively hot, dusty, or strong electromagnetic envrionment.
Do not vibrate, shake, or drop the device.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.