![]()
LOCATION AND DESCRIPTION OF CONTROLS
Please read the instruction carefully before operating the unit.
![Muse - M-102 DB - LOCATION AND DESCRIPTION OF CONTROLS - Part 1 LOCATION AND DESCRIPTION OF CONTROLS - Part 1]()
![Muse - M-102 DB - LOCATION AND DESCRIPTION OF CONTROLS - Part 2 LOCATION AND DESCRIPTION OF CONTROLS - Part 2]()
- LCD display
- DAB+/FM telescopic antenna
- SCAN: Auto scan
/ MODE button: To turn unit on/ Standby; To select function mode: DAB, FM - PREV button: Skip
- INFO/MENU button: To access the main menu / To review the setting information
- NEXT button: Skip
- PRESET: Preset radio stations
- VOL+ button: Volume up
- OK button: Confirm the selection
SNOOZE
DIMMER: to adjust display brightness - VOL- button: Volume down
- OFF/ON switch
- Phones jack
- DC IN jack
- Battery compartment
POWER SUPPLY
AC ADAPTOR
The supplied AC adaptor is suitable for use on AC main supplies of AC 100-240V
50/60Hz and should only be connected to a mains supply within these parameters.
![]()
- The AC adaptor included with this unit is for its use only. Do not use it with other equipment.
- Turn off the unit before unplugging the AC adaptor from the unit so as to avoid the unit being damaged.
- When the unit is not going to be used for long time, disconnect the AC adaptor from the AC outlet.
- Be sure to use it near the wall outlet and easily accessible. If a malfunction occurs, disconnect the plug from the wall outlet at once.
- AC adaptor is used as the disconnect device. It shall remain readily operable and should not be obstructed during intended use. To be completely disconnected the apparatus from supply mains, the AC adaptor of the apparatus shall be disconnected from the mains socket outlet completely.
- Never use an AC adaptor that is damaged, route power lead in a safe manner and make sure it is not subjected to trapping or pinching. If the power lead is damaged refer to a qualified service agent.
- The AC adaptor must be unplugged from the DC jack for the unit to run on the batteries.
BATTERY OPERATION
- Remove the battery compartment door by applying thumb pressure to area indicated on battery door and then lift the door out and off the cabinet.
- Before inserting the batteries, observe the polarities (+ and -) of the battery, then relate the polarities to the engraved diagram inside the battery compartment, insert 4x1.5V, R6/UM3/"AA" batteries (not supplied) into the compartment.
- Replace the compartment door.
![]()
Before throwing any batteries away, consult your distributor who may be able to take them back for specific recycling.
NOTES:
- Never recharge the batteries, apply heat to them or take them apart.
- In order to avoid leakage, always remove the batteries when unit will not be used for a long period of time.
- For optimal performance, alkaline batteries are recommended. These batteries must be replaced every six months.
- The batteries need to be replaced when: The volume decreases, or sound is distorted during operation.
- "Battery low" will show on display when the battery power is low.
![]()
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
TURNING ON/OFF THE UNIT
To turn on the unit, slide the POWER ON/OFF switch to "ON" position on back of unit, then press
/ MODE to turn on the unit.
To turn off the unit, slide the POWER ON/OFF switch to "OFF" position on back of unit.
Press and hold the
/ MODE button to go to Standby mode.
SELECTION FUNCTION
When the unit is on, repeatedly press
/ MODE button to select desired mode: FM or DAB.
ADJUSTING VOLUME
To increase or decrease the sound level, press VOL+/VOL-.
SETTING THE TIME AND DATE
The first time you listen to DAB radio, the time and date of your product will synchronised automatically to that broadcast by the DAB service in 24 hours mode, which is in line with daylight saving, so there is no need to set the time and date manually.
If you do wish to set the time and date manually, turn on the radio and follow the steps as below:
- Press and hold the INFO/MENU button.
- Press PREV/NEXT button to <Time/Date>. Press OK button to enter this option.
- <Set Time> is displayed. Use the PREV/NEXT button to set the hour. Press the OK button to confirm. Use the PREV/NEXT button to set the minutes. Press the OK button to confirm. Use the PREV/NEXT button to set the second, Press the OK button to confirm.
- <Set Time> is displayed. Use the PREV/NEXT button and OK button to set the year, month and date.
LISTENING TO DAB/DAB+ RADIO
- Repeatedly press
/ MODE button to select DAB mode. The radio will start automatic scan for DAB stations if it's the first time to use the unit. The display will display a progress bar. A progress bar will show the progress of the scan and the number of stations found during the scan will also be displayed. - When the scan is complete, the radio will select the first available station and begin to broadcast. Stations are listed in numerical and then alphabetical order by default.
Note: The DAB radio station list is stored in the memory and so the next time you switch your radio on, the station search does not take place. It is possible to scan manually for stations by pressing and releasing the SCAN button. - Use PREV/NEXT button to select through the list of stations.
- When the desired station is displayed, press the OK button to confirm. There will be a short delay while your radio tunes to your selected station.
Note:
- If no broadcasts are found by DAB/DAB+ scan, "No Station" appears in the display.
- For a better reception, extend the telescopic antenna or do the full scan again in another place.
- During the search operation, the sound level is automatically muted.
LISTENING TO FM RADIO
In FM radio mode, press PREV/NEXT button manually. Press SCAN button once to search automatically.
Note: For a better reception, extend the telescopic antenna.
PRESET STATIONS
This unit can store 10 FM and 10 DAB/DAB+ stations.
- Repeatedly press
/ MODE button to select FM or DAB/DAB+ band. - Select a radio station.
- Press and hold PRESET button to enter preset store mode.
- Use PREV/NEXT button knob to select a channel.
Note: If you choose a station that hasn't been allocated, "Empty" will be displayed. If the station has been allocated before, the frequency will be showed. - Press OK button to save it. "Stored" will be displayed.
- Repeat step 1-5 to store other stations.
LISTENING TO RADIO PRESETS
- Press
/ MODE button to select FM or DAB/DAB+ band. - Press PRESET once. "Preset Recall" will be displayed, then use PREV/NEXT button to select your desire station.
- Press OK to confirm your selection.
Repeatedly press INFO/MENU button to review some unit settings (e.g. time, date, frequency) or available information (e.g. radio text, program type) for the station you are listening.
Navigating the setup menu. In FM or DAB mode, press and hold INFO/MENU to enter into setup menu.
FM / DAB Setting Menu
Time / Date
You can adjust the time and date setting.
System version (Software-Version)
To display the current software version.
Factory reset
To clear all users defined settings.
When you enter into reset mode, use PREV/NEXT button to select "Yes", press OK button to confirm to restore to factory default settings. Use PREV/NEXT button to select "No", press OK to cancel this selection.
Alarm 1 Set/Alarm 2 Set
You can set the alarm.
Sleep set
You can set the sleep function.
Language
To select the desired language of the unit's menu: English, French, Dutch and Deutsch.
Time Sync
For time auto update.
When the display shows "Time Sync", press OK button to confirm. Use PREV or NEXT button to select "Update radio" or "No update", press OK button to confirm.
12H or 24H
Press PREV/NEXT to adjust 12 or 24 hour format.
FM scan setting
Only: The automatic search only locates at strong stations.
All: The automatic search locates at any available station.
Bat efficient (Battery efficient setting)
When the display shows "Bat efficient", press OK button to confirm. Use PREV or NEXT button to select "ON" or "OFF", press OK button to confirm. If you selected "ON", when no control on the unit in standby mode, the unit will be off automatically after 2 minutes.
Stereo / Mono
To select between "Stereo" and "Mono" for the FM radio.
Prune
Remove stations that are listed but unavailable. This function can remove all invalid stations indicated in the station list with a "?" in front of the station name. (DAB mode only)
SETTING THE ALARM AND THE ALARM MODE
When the time has been set.
- Press and hold INFO/MENU button in FM or DAB mode.
- Press PREV/NEXT button to choose <Alarm 1 Set> or <Alarm 2 Set>, press OK button to confirm.
- Repeatedly press PREV/NEXT button to select <ON>, then press OK button to confirm.
- Press PREV/NEXT button to set the hour, press OK button to confirm. Press PREV/NEXT button to set the minutes, press OK button to confirm.
- Then press PREV/NEXT button to set the volume, press OK button to confirm.
- Repeatedly press PREV/NEXT button to select the source of wake up by Buzzer, DAB or FM. Press OK button to confirm.
- Repeatedly press PREV/NEXT button to specify one of the following alarm frequency options: "Daily", "Once", "Weekends" and "Weekdays". Press OK button to confirm.
- In standby mode, "
" or "
" will be shown on display.
Note:
- Same procedure applies for alarm 2.
- If you wake up with last radio, select your desire station, then press
/ MODE button to turn off the radio before alarm time reaches. For the station selecting, please refer to "Listen to DAB/DAB+ radio" and "Listen to FM radio".
Stopping the alarm
- Alarm repetition
Press SNOOZE button. The alarm stops and will sound again 9 minutes later. - Alarm stop
Press
/ MODE button. The alarm 1 or alarm 2 will sound again the next day at the same time.
Note:
- If you select the alarm frequency by "Once", the alarm will not sound again.
- If you select the alarm frequency by "Daily", the alarm will sound again.
- If you select the alarm frequency by "Weekend", the alarm will sound again at each weekend.
- If you select the alarm frequency by "Weekdays", the alarm will sound again except weekend.
-
Alarm Cancellation
- Press and hold INFO/MENU button in FM or DAB mode.
- Press PREV/NEXT button to choose <Alarm 1 Set> or <Alarm 2 Set>, press OK button to confirm.
- Repeatedly press PREV/NEXT button to select <OFF>, then press OK button to confirm.
SLEEP FUNCTION
- Press and hold INFO/MENU button in FM or DAB mode.
- Repeatedly press PREV/NEXT button to select <Sleep Set>, then press OK button to confirm.
- To fall asleep with the radio, repeatedly press SLEEP to select 120-90-60-45-30- 15-5 minutes of listening. The unit will automatically turn off after the specified time. To cancel the sleep function, repeatedly press PREV/NEXT button until "OFF" display, press OK button to confirm.
DIMMER
In standby mode, press DIMMER button repeatedly to select the brightness of the screen.
USING HEADPHONES / EARPHONES (NOT INCLUDED)
Maximum output voltage ≤ 150mV
HEADPHONE VOLUME WARNING
Connect earphones with the volume set low and increase it if required. Prolonged listening through some earphones at high volume settings can result in hearing damage. When headphones/earphones are connected, no sound will be emitted from the unit's speaker.
![]()
Avoid listening to sound at levels which may be harmful to your ears.
To prevent possible hearing damage, do not listen at high volume levels for long periods.
![]()
TECHNICAL SPECIFICATIONS
POWER SUPPLY:
DC IN 5V
1A
DC
4X1.5V, battery type R6/UM3/AA (not provided)
RADIO FREQUENCY:
FM: 87.5 - 108 MHz
DAB/DAB+: 174.928-239.2 MHz
Design and specifications are subject to change without notice.
Hereby, NEW ONE S.A.S, declares that this MUSE M-102 DB is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
The declaration of conformity may be consulted at www.muse-europe.com
![]()
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Need help?
Do you have a question about the M-102 DB and is the answer not in the manual?
Questions and answers