Table of Contents
Advertisement
Precautions for filter
Because of freezing, the flow switch may be broken in winter. Therefore, Disconnect torch water hose
from the power supply or keep water flowing at very low pressure.
Precautions for filter
By means of setting the attached filter to the water inlet on the rear side of the welding machine, you can
prevent the inside of the water flow switch and the water conduct of torch from accumulating dust or fur.
Please fix the filter in the following way.
The way of setting the filter.
Put the filter in the adapter and setting it to the water inlet on the rear side of the welding machine.
②set the water hose to the adapter
Maintenance for filter
When the water conduct comes to be used for a long time and dust or fur is accumulated in the filter,
there might be the case the 'Warning Lamp' turns on and the machine stops. Therefore, clean the filter
once or twice per month
※ The way of cleaning
①Remove the adapter
② Take out the filter,
③Remove dust or fur accumulated on the wire net of the filter by washing or brushing.
④Set the filter.
13
Advertisement
Table of Contents
