Parameter
AA101
AA111
The RapidPath plugin controls (writes to) some parameters for operation. If you change the
value of any of them, your change will be overwritten.
This can be done automatically via Mach.
Go to Configure | Plugins | RapidPath - MachMotion:
Select the Other Devices tab, Click on the Hitachi VFD in the dropdown on the left and then select
the Device Parameters at the bottom of the page:
Description
Main Speed Source_M
Run-cmd. Source_M1
Parameter
CC-01
CC-02
CC-06
CC-07
Default Value
1 (Term.[Ai1])
0 (Term.[FW]/[RV])
Desired Value
9 (Option-1)
4 (Option-1)