PARTS AND FEATURES TILT HEAD STAND MIXER PARTS AND ACCESSORIES Motor Head (locking lever not shown) Bowl** Attachment Knob Beater Shaft Attachment Hub Pouring shield* Motor Head 3 L Stainless Steel Bowl* Speed Control Lever Flat Beater Beater Height Adjustment screw Flex Edge Beater* (not shown) Wire Whip...
Page 3
PARTS AND FEATURES BOWL LIFT STAND MIXER PARTS AND ACCESSORIES Motor Head Attachment Knob Speed Control Lever Attachment Hub (see the “Optional Attachments” Beater Height Adjustment screw section) Bowl Support Pouring Shield* Locating Pins Flat Beater Stainless Steel Bowl** Flex Edge Beater* Beater Shaft Wire Whip Bowl Lift Lever (not shown)
PRODUCT SAFETY IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all instructions. Misuse of appliance may result in personal injury. 2. To protect against risk of electrical shock, do not put Stand Mixer in water or other liquid.
- staff kitchen areas in shops, offices or other working environments; - farmhouses; - by clients in hotels, motels and other residential type environments; - bed and breakfast type environments. SAVE THESE INSTRUCTIONS ELECTRICAL REQUIREMENTS 5KSM150PSP Series Wattage: 300 W Volts: 230V Hertz: 60 Hz 5K45SSP Series Wattage: 275 W...
SPEED CONTROL GUIDE Speed Action Description Stir For slow stirring, combining, mashing, starting all mixing procedures. Use to add flour and dry ingredients to batter and to add liquids to dry ingredients. Do not use Speed 1 to mix or knead yeast doughs. Slow mixing For slow mixing, mashing, faster stirring.
PRODUCT USAGE ASSEMBLING/DISASSEMBLING YOUR TILT HEAD STAND MIXER To remove Flat Beater, Wire Whip, Dough Hook or Flex Edge Beater*: 1. Turn speed control to 0 (off) and unplug. 2. Raise motor head. 3. Press beater upward as far as possible and turn left.
Page 8
PRODUCT USAGE ASSEMBLING/DISASSEMBLING YOUR BOWL LIFT STAND MIXER 2. Bowl must always be in raised, lock position when mixing. To Lower Bowl 1. Rotate lever back and down. To Attach Flat Beater, Wire Whip, Dough Hook or Flex Edge Beater*: 1.
Page 9
PRODUCT USAGE To attach Pouring Shield*: 1. Turn speed control to “0” (Off). 2. Unplug Stand Mixer or disconnect power. 3. Attach Flat Beater, Wire Whip, Dough Hook or Flex Edge Beater* and Bowl. Front the front of the mixer, slide the Pouring Shield* over the bowl...
OPTIONAL ATTACHMENTS KitchenAid offers a wide range of optional attachments such as the Spiralizer, Pasta Cutters, or Food Grinder that may be attached to the Stand Mixer attachment power hub as shown below. Turn the Stand Mixer to “0” (Off) and Remove the attachment hub cover.
OPTIONAL ATTACHMENTS Lift the front of the pouring shield* clear Turn the Stand Mixer to “0” (Off) and of the rim of the bowl. Pull away from the then unplug the stand mixer. Stand Mixer. CARE AND CLEANING IMPORTANT: Do not immerse the Stand Mixer body in water or other liquids. Dishwasher-safe parts, top rack only: Stainless steel bowl*, bowl , flat beater, Turn the Stand Mixer to “0”...
TROUBLESHOOTING GUIDE WARNING Electrical Shock Hazard Plug into an earthed outlet. Do not remove an earth prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, re, or electrical shock. Problem Solution Under heavy loads with extended mixing time periods, you...