Download Print this page
Panasonic ET-LAB50 Replacement Instructions
Panasonic ET-LAB50 Replacement Instructions

Panasonic ET-LAB50 Replacement Instructions

Lamp unit for lcd projector

Advertisement

Quick Links

Read these instructions completely before replacement.
Information for Users on Collection and Disposal of Old Equipment and
used Batteries
These symbols on the products, packaging, and/or accompanying
documents mean that used electrical and electronic products and
batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and
used batteries, please take them to applicable collection points,
in accordance with your national legislation and the Directives
2002/96/EC and 2006/66/EC.
By disposing of these products and batteries correctly, you
will help to save valuable resources and prevent any potential
negative effects on human health and the environment which
could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products
and batteries, please contact your local municipality, your waste
disposal service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste,
in accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please
contact your dealer or supplier for further information.
[Information on Disposal in other Countries outside the European Union]
These symbols are only valid in the European Union. If you wish
to discard these items, please contact your local authorities or
dealer and ask for the correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical
symbol. In this case it complies with the requirement set by the
Directive for the chemical involved.
Replacement Instructions
Lamp unit for LCD Projector
ET-LAB50
Model No.
TQZH747-6

Advertisement

loading

Summary of Contents for Panasonic ET-LAB50

  • Page 1 Replacement Instructions Lamp unit for LCD Projector ET-LAB50 Model No. Read these instructions completely before replacement. Information for Users on Collection and Disposal of Old Equipment and used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste.
  • Page 2 Precautions with regard to safety WARNING The lamp unit should only be replaced by a qualified technician. When replacing the lamp, allow it to cool for at least one hour before handling it. • The lamp cover gets very hot, and contact with it can cause burns. Caution If the lamp has broken, ventilate the room immediately. Do not touch or bring your face close to the broken pieces.
  • Page 3 Lamp unit replacement procedure Check that the area around Insert the new lamp unit while making sure that the lamp unit has cooled the direction of insertion down. is correct, and then use a Phillips screwdriver to Use a Phillips screwdriver securely tighten the lamp to turn the lamp unit cover unit fixing screws.
  • Page 4 • Replace the air lter with the new lter which is supplied as an accessory, while referring to the replacement procedure which appears in the Operating Instructions for the LCD projector. Accessory • Air lter: 1 Web Site : https://panasonic.net/cns/projector/ Printed in Japan...