2
Setting the
Address Switch
Note
LOCATE AND SET THE LOGICAL SWITCH
18 Configuring the RF Multiplexer
The logical address switch (LADDR) factory setting is 120. You may have
changed the setting during module installation. Valid address values are from 0 to
255. If the RF Multiplexer is used with an HP Command Module in a C Size
Mainframe, refer to the " HP Command Module User's Guide" for addressing
information. Otherwise, use Figure 2-1 to change the setting.
The address switch selected value must be a multiple of 8 if the module is the first
module in a "switchbox" used in a VXIbus mainframe, and being instructed by
SCPI commands.
Figure 2-4 Address Selection
Chapter 2