Replacing An Ssd Drive On An Re-S-X6-64G - Juniper MX480 Hardware Manual

MX480 3D Universal Edge Router Hardware Guide
Related
Documentation

Replacing an SSD Drive on an RE-S-X6-64G

306
Remove the storage drive.
2.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
a.
connect the strap to an ESD point on the appliance.
For more information about ESD, see Preventing Electrostatic Discharge Damage
in the hardware guide for your router.
Unfasten the thumbscrew that secures the access door in front of the storage drive
b.
slots, and open the door.
Slide the lock on the ejector to the unlocked position.
c.
Carefully slide the drive out of the slot.
d.
Reinstall a storage drive.
3.
Carefully align the sides of the drive with the guides in the slot.
a.
Slide the drive into the slot until you feel resistance, carefully ensuring that it is
b.
correctly aligned.
Close the access door and tighten the thumbscrew to secure the door.
c.
Returning a Hardware Component to Juniper Networks, Inc. on page 474
Each RE-S-X6-64G Routing Engine supports two solid-state drives (SSD) specified by
Juniper Networks. The RE-S-X6-64G ships with two SSDs installed in the slot labeled
and . Figure 126 on page 307
DISK1 DISK2
a RE-S-X6-64G Routing Engine.
Replacing an SSD drive in a RE-S-X6-64G Routing Engine consists of the following two
stages:
Replacing the SSD Drive in the Routing Engine.
1.
Copying vmhost and Junos OS to the replaced SSD.
2.
shows the arrangement of storage drive slots on
Copyright © 2017, Juniper Networks, Inc.