NorthStar 6000i Installation Manual page 15

Wiring heading sensors
The WA215SR cable is pre-wired with a connector for interfacing to various heading sensors. Other
sensors can be connected as shown in the following tables.
ROBERTSON RFC35N HEADING
SENSOR
Wire Color
Brown
White
Green
Yellow
Pink
Gray
KVH AUTOCOMP 1000 HEADING
SENSOR (P/N 01-0118-0001)
Wire Color
Orange
Green
White
Brown
Blue
Red
Black
Drain, Foil,
Shield
R2D Radar Installation Manual, Rev. A
Description
Tx– Data Ground
Tx + Data Transmit
Rx– Data Ground Not Connected
Rx+ Data Receive Not Connected
Vin+ Power A+ Ship's Power Supply, Fused, 12 VDC
Vin– Power Ground Ship's Power Ground
Description
NMEA 0183 Out –
NMEA 0183 Out +
Damping 0 Connect to Power Ground
Damping 1 Connect to Power Ground
AutoComp Disable Do not connect. Cap and Insulate
12 VDC Power Ship's Power Supply, Fused, 12 VDC
Power Ground Ship's Power Ground
not used Not Connected
SECTION TWO: Installing and wiring the radar
NORTHSTAR NMEA 18-PIN CONNECTOR
Pin No. Wire Color
1 Blue
3 Brown
NORTHSTAR NMEA 18-PIN CONNECTOR
Pin No. Wire Color
1 Blue
3 Brown
Description
NMEA Port 1 in B
NMEA Port 1 In A
Description
NMEA Port 1 in B
NMEA Port 1 In A
Page 11