NorthStar 6000i Installation Manual page 14

SECTION TWO: Installing and wiring the radar
An appropriate relay for Option 3 (with a 12-volt coil, and complete with
instructions) is available from Northstar as part number RELAY-IK. An appropriate
relay can also be obtained from Greenwich Electronics (www.geirelays.com, or
888-554-5561) using P/N HD1-012D-A30PMS for a 12-volt system, or
HD1-024D-A30PMS for a 24-volt system. Using this relay, the coil is connected to
the narrow tabs and the contacts are connected to the wide tabs (labelled COM and
NO).
If the relay is used for power control, the navigator's Honk output must be configured for power
control as follows:
1. Press the STAR key to display the alarms page.
2. Press the Cursor Pad down to highlight " Honk Output. "
3. Press Edit , press the Cursor Pad up or down to display REMOTE PWR .
4. Press ENTER .
The 200ppnm or alarm outputs can not be used when this output is used for power
control.
Page 10
Note: Choose a relay that's compatible with the ship's power
Figure 10: Using a relay to control radar power
R2D Radar Installation Manual, Rev. A