Hitachi UX2 Technical Manual page 142

(5) Attach the M4 screws removed in Step (1) to their original positions.
(6) Align the Slide base with the grooves of the slide block, and slide the jig to install it.
* Make sure to perform
Step (3).
Otherwise, Cleaning
station may drop.
(7) Install the cleaning unit stopper (one piece) on the Slide base, and fix the Cleaning Station with the
supplied M3 screws.
● The M3 screw for fixing the cleaning unit stopper is a tapping screw. If the screw is tightened
excessively, the screw hole may be damaged.
118
NOTE
Slide base
Slide stopper
Screws removed in Step (1)
Cleaning Station
Slide block
Groove
Slide Base
M3 screws
(Tighten one of the
screws at 2
locations.)