Yamaha AG08 User Manual page 29

Getting ready to use this product > Connecting to your computer and configuring the settings (Mac)
NOTE
In step 2, when you select [Yamaha AG08 Voice / CH5-6], only the channel 1 and channel 2 mix from this product is
(
inputted to the computer, and the computer starts outputting to the USB inputs of channels 5/6 on this product. Use the
[LINE/USB] selector switch for channels 5/6 on this product to select "USB".
In step 2, when you select Yamaha AG08 AUX / CH7-8, the AUX OUT from this product (see the block diagram for details)
(
is inputted to the computer, and the computer starts outputting to the USB inputs of channels 7/8 on this product. Use
the [LINE/USB] selector switch for channels 7/8 on this product to select "USB".
AG08 Controller app SOUND PAD audio files used for import or while adjusting the sound are output according to these
(
settings.
6
Quit "Audio MIDI Setup."
NOTE
This product can be powered by a computer that has a USB Type-C port supplying at least 5 V/1.5 A of current via a USB-C
to USB-C cable, without the need to connect a AC adapter.
1) Remove all USB devices from your computer except for the mouse and keyboard.
2) Make sure that the volume on this product and on the connected device is turned all the way down.
3) After installing the driver, use the included USB cable to connect this product to the computer, and slide the [POWER
SOURCE] selector switch on the rear panel to the [USB 2.0] port side (right side).
Connect the devices directly without using a USB hub.
4) Turn the [z] (standby/on) switch on.
5) After the LED light animation on the top panel of this unit finishes, check whether the LED of the [z] (standby/on)
switch on this product is lit.
If you've connected the devices before installing the driver, go ahead and install the driver.
The LED of the [z] (standby/on) switch on this product flashes when there is not enough power supplied from the
computer, and this product will not start up normally. In this case, use the included AC adapter.
29