Sony DVS-9000 User Manual page 430

2
In the <Serial Tally Port> group, select the port to which the setting
applies.
3
Using any of the following methods, select the port bit number.
• Press directly on the list on the left of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
4
Turn the knob to select the source address.
Knob
2
5
Press [Source Address Set].
This confirms the setting.
Clearing a source address setting
To clear a source address setting for a particular bit
In the Router/Tally >Serial Tally >Source Assign menu, select the serial tally
port and bit number (see steps 2 and 3 in the previous item), then press [Clear].
This clears the source address setting for the selected bit.
To clear all source address settings
In the Router/Tally >Serial Tally >Source Assign menu, select the serial tally
port, then press [All Clear].
A confirmation message appears.
• If you select "Yes," this clears all source address settings for the selected
serial tally port.
• If you select "No," the clear operation is canceled.
Parameter Adjustment
Bit No Bit selection
Parameter Adjustment
Source Addr Source address selection
Setting values
1 to 128
Setting values
1 to 1024
Setup Relating to Router Interface and Tally
429