Installing The Outer Rails To The Rack; Preparing The Outer Rails For Installation To The Rack - Bosch DIVAR IP all-in-one 6000 Installation Manual

22 en | Rack installation
5.
5.2

Installing the outer rails to the rack

Each outer rail consists of two sections, a long section and a short section. Both sections are
delivered separate and must be assembled, before installing the outer rail to the rack.
The long section is to be placed at the front of the rack and the short section at the rear of the
rack.
You can adjust the distance between the two sections, so that the outer rail fits into different
sizes of racks.
The design of both outer rails is symmetric to allow an installation without left/right
restriction.
The outer rails come with a mounting bracket pre-installed on both ends of the outer rail. The
mounting bracket allows for installation in square-hole racks without using any tools.
Depending on the type of the rack, the installation procedure slightly differs.
Refer to
–
–
–
5.2.1

Preparing the outer rails for installation to the rack

To prepare the outer rails for installation to the rack:
1.
2022-10 | V02 | F.01U.407.903
Repeat these steps for the other inner rail extension.
Installing the outer rails in a square-hole rack, page 23
Installing the outer rails in a round-hole threaded rack, page 24
Installing the outer rails in a round-hole rack, page 25
Slide the long section of the outer rail into the short section.
1
2
Installation manual
DIVAR IP all-in-one 6000
3
Bosch Security Systems B.V.