Hardware Requirements - Huawei eNodeB User Manual

eNodeB
LMT User Guide
2.1 Functions of the eNodeB LMT
The eNodeB LMT deploys the eNodeB and identifies and clears faults locally.
Use the LMT to operate and maintain the eNodeB in any of the following scenarios:
l
l
l
The LMT provides a Graphical User Interface (GUI), which helps users operate and maintain
the eNodeB on the web page. It i mplements the following local operation and maintenance
(O&M) functions:
l
l
l
l
l
l
l
l
2.2 System Requirements for the LMT Installation
This section describes the system requirements for the LMT installation.

Hardware Requirements

Table 2-1 lists the hardware requirements for the LMT installation.
Table 2-1 Hardware requirements
Item
CPU
RAM
Hard disk
Issue 01 (2011-09-15)
When the transport link between the eNodeB and the M2000 is unavailable, use the LMT
to start the eNodeB locally.
When the eNodeB fails to communicate with the M2000, use the LMT to identify and clear
faults locally.
When alarms are generated on the eNodeB and related boards must be replaced locally,
use the LMT to identify and clear faults.
NOTE
When the eNodeB communicates with the M2000 properly, Huawei recommends that you operate and
maintain the eNodeB at the network management center (NMC). When you must obtain information from
the M2000 for fault identification, the M2000 may fail to provide adequate information because it manages
many network elements (NEs). At this time, use the LMT to operate and maintain the eNodeB.
Running eNodeB MML commands
Managing eNodeB alarms
Running MML commands in batches
Tracing messages
Monitoring eNodeB performance in real time
Software Management
Enabling the eNodeB to perform self-test
Maintenance
Recommended
Configuration
2.8 GHz or higher
1 GB
80 GB
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Introduction to the eNodeB LMT
Minimum Configuration
866 MHz
512 MB
10 GB
4