International Door Closers 854 Installation Instructions

SPEED
ADJUSTING
VALVE

PLEASE NOTE

This drawing is not to full scale. Therefore, do not use it as your template to locate the hole positions while you fabricate your door and frame for the
installation of this product. Instead, make the measurements needed manually without the use of the enclosed template which is not to full scale.

REGULAR ARM (PULL SIDE) MOUNTING

1
(25)
3/4
(19)
4
(101)
4
(101)
3/4
(19)
1/2
(12.7)
International Door Closers, Inc.
COPYRIGHT 2023 INTERNATIONAL DOOR CLOSERS, INC
INSTALLATION
INSTRUCTIONS
Right Hand Door
6-1/2
1-3/4
(165)
(44.4)
9-1/16
(230)
9-1/16
(230)
6-1/4 1-3/4 1-3/4
(159) (44.4) (44.4)
1804/1804BC, 1805/1805BC, 8051-TP
B
Type
PULL
SPEED
Side of Door
ADJUSTING
VALVE
1
(25.4)
INSTALLATION INSTRUCTIONS
1. Use dimensions shown beside, mark FOUR (4) HOLES ON DOOR for door closer
and TWO (2) HOLES ON FRAME for arm shoe.
2. Drill pilot holes in door and frame for #14 all-purpose screws or drill and tap for
1/4-20 machine screws.
3. Install adjustable forearm/arm shoe to frame using screws provided.
4. Mount closer on door using screws provided. SPEED ADJUSTING VALVES MUST
BE POSITIONED TOWARD HINGE EDGE.
5. For Regular Arm Mounting, install main arm to top pinion shaft, perpendicular to
door as shown on left (A Type). For Top Jamb Mounting, install main arm to bottom
pinion shaft, perpendicular to door as shown on left (B Type). Secure tightly with arm
screw/washer assembly provided.
6. Adjust length of forearm so that forearm is perpendicular to frame when
assembled to preloaded main arm. Secure forearm to main arm with screw/washer
assembly provided.
7. Adjust closing speed of door.
8. For Regular Arm Mounting, snap pinion cap over shaft at bottom of closer. For Top
Jamb Mounting, snap pinion cap over shaft at top of closer.
West: 800-544-4422 • East: 800-225-6737
(Page 1 of 2)
Surface Mounted 854 / 884
TOP JAMB INSTALLATION
Left Hand Door
www.intldoorclosers.com
Body Size 4
PUSH
Side of Door