Epson ET-18100 Series User Manual page 79

In These Situations
If you do not know where the [WPS] button is, or there are no buttons on the wireless router, see the
documentation provided with your wireless router for details.
2. Hold down the button on the printer for at least 5 seconds until the
alternately.
The connection setting will start. When a connection is established, the
Note:
The printer is in a connection error status when the
printer error by pressing the
again. If it still does not work, print a network connection report and check the solution.
Making Wi-Fi Settings by PIN Code Setup (WPS)
You can connect to an wireless router by using a PIN code that is printed on the network status sheet. You can use
this method to set up if an wireless router is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a
PIN code into the wireless router.
1. Load papers.
2. Hold down the button on the printer for at least 5 seconds.
The network status sheet is printed.
Note:
If you release the button within 5 seconds, a network connection report is printed. Note that PIN code information
is not printed on this report.
3. While holding down the
4. Use your computer to enter the PIN code (an eight digit number) printed on [WPS-PIN Code] column of the
network status sheet into the wireless router within two minutes.
When a connection is established, the
>
Re-Setting the Network Connection
button on the printer, reboot the wireless router, place it close to the printer and try
button, press the
light turns on.
>
Making Wi-Fi Settings from the Control Panel
light and the light flash simultaneously. After clearing the
button until the light and the
79
light and the light flash
light turns on.
light flash alternately.