Commissioning; Configuration And Operation; Led Signals During Operation - Beko METPOINT FLM SF53 Installation And Operation Instruction Manual

EN

5. Commissioning

To start the METPOINT FLM, power it and perform the sensor setup as described in "Sensor Setup" on page 28. Slowly
®
pressurize the pipes.
6. Configuration and operation
When the METPOINT FLM is parted, it is automatically initialized. After this step is completed, main menu is displayed.
®
The device menus are operated through two capacitive buttons:
>>UP<< >>ENTER<<

6.1. LED signals during operation

type of gas /
status message
HW-Version
SW-Version
Press the >>UP<< button to call up pages 2 - 5.
METPOINT SF53
®
cfm
cf
Modbus ID
page no.
cpm
fpm
° F
CAL indicates calibration:
After 15 months, CAL shows the upcoming calibration on the
display. The display does not influence the measured values.
The measurement signal is still output.
The time interval can be adjusted as requested by the customer
in the manufacturing plant.
l
Installation and operating manual
fpm
° F
27