Status Codes; Error Messages - Siemens Pointek CLS200 Operating Instructions Manual

7.2.2

Status codes

Every measured value which can be displayed is given a status to identify its quality. If it is
classified as Bad or Uncertain the text Error alternates with the measured value in the display
and the status code alternates with the unit or Bar Graph.
If the status is Bad or Uncertain, either a status code or a status message is displayed in the
auxiliary display. If the selection for Local Status text is numeric a numeric code will be
displayed. If a language is selected, a text message will be displayed. (For details see Mode
27: Local Status Text (default: U_075) (Page 52)).
The status display has priority, and neither the physical unit nor the Bar Graph is visible if the
status is Bad or Uncertain.
Examples:
LUI Status Code
Bar graph displayed
G_164
U_075
B_016
The status codes can be found in Status (Page 64).
7.2.3

Error messages

In the case of exceptional events, error messages can appear during local operation and are
displayed for around 10 seconds after the occurrence of the error.
Error code Meaning
F_001
F_002
F_003
F_004
F_008
Pointek CLS200/CLS300 digital
Operating Instructions, 05/2021, A5E47904060-AA
Quality
Good
Good
Uncertain
Bad
Error messages available
Local operation disabled
Change of bus address not possible as the device is
exchanging data with master class 1
Change of PROFIBUS Ident Number not possible as
the device is exchanging data with master class 1
Value too large to fit in LCD display (>99999 or <-
99999)
Local adjustment of parameters blocked by SIMATIC
PDM
7.2 Programming via the Local User Interface (LUI)
Error
Maintenance required
Substitute value - Constant output
Sensor failure
Corrective Action
Release HW Write Protection
End communication with master
class 1
End communication with master
class 1
Change display value units
Enable "Local operation" with
SIMATIC PDM
Local operation
41