Sanyo MLR-350 Instruction Manual page 7

PRECAUTIONS FOR SAFE OPERATION
[ � - � - !
• Make sure that the power supply to the unit is disconnected when the fluorescent light is
� replaced as this will prevent electric shock.
• Disconnect the power supply plug if there is something wrong with the unit.
� abnormal operation may cause electric shock or fire.
0
If the unit is to be stored unused in an unsupervised area for an extended period,
o
do not have access and that doors cannot be closed completely.
The disposal of the unit should be accomplished by appropriate personnel. Always remove
doors to prevent accidents such as suffocation,
0
Make sure to prepare a safety check sheet when you request any repair or maintenance for the
safety of service personnel.
[�-�- !
0
Select a level and sturdy floor for installation. This precaution will prevent the unit from tipping.
Improper installation may result in water spillage or injury from the unit tipping over.
r<::'\
Do not put a thing more than 30 kg on the shelf and do not throw a thing into the chamber.
\..Y Falling may cause injury.
0
Make sure a dedicated power source is used as indicated on the rating label attached to the unit.
0
o
Fix the shelves securely .
When removing the plug from the power supply outlet, grip the power supply plug, not the cord.·
Pulling the cord ma y result in electric shock or fire by short circuit.
r<::'\
Never damage or break the power supply plug or cord. Do not use the supply plug if its cord is
\..Y loose. This may cause fire or electric shock. .
r<::'\
Do not touch any electrical parts such as the power supply plug or any switches with a wet hand.
\..Y This may cause electric shock.
0
Confirm the setting point
setting point may cause injury (har m ing) to contents.
W�A_ · R_N_I N _ G�]
_CA_U_T_I O _ N ______,]
. Incomplete installation may cause injury or damage.
if resume operation after power failure or turning off.
_
4
Continued
ensure that children
·,
Changing of..