Precautions For Safe Operation - Sanyo MLR-350 Instruction Manual

PRECAUTIONS FOR SAFE OPERATION

[�_Lt!
Do not use the unit outdoors. Current leakage or electric shock may result if the unit is exposed to
1"\
\Y .rain water.
0
Only qualified engineers or service personnel should install the unit.
unqualified personnel may cause electric shock or fire.
0
Be sure to install the unit on a sturdy floor. If the floor is not strong enough or the installation site is
not adequate, this may result in injury from the unit falling or tipping over.
Never install the unit in a humid place or a place where it is likely to be splashed by water.
1"\
\Y Deterioration of the insulation may result which could cause current leakage or electric shock.
0
Connect the unit to a power source·as indicated on the rating label attached to the unit. Use of
any other voltage or frequency other than that on the rating label may cause fire or electric shock.
0
Make sure to remove dust from the power supply plug before inserting in a power source. A dusty
o
plug or improper insertion may pose a hazard.
.
Use a power supply outlet with ground (earth) to prevent electric shock.
is not grounded, it will be necessary to install a ground by qualified engineers.
Never ground the unit through a gas pipe, water main, telephone line or lightning rod. Such
1"\
\Y grounding may cause electric shock in the case of an incomplete circuit.
Do not insert metal objects such as a pin or a wire into any vent, gap or any outlet for inner air
1"\
\Y circulation. This may cause electric shock or injury by accidental contact with moving parts.
0
Never store volatile or flammable substances in this unit. This may cause explosion or fire.
0
If this unit is to be used for storing poisons, radioactive material or other harmful products
it is in a safe area. Failure to do so may lead to an adverse effect on the health of personnel in the
area and the local environment.
.,. Always disconnect the power supply to the unit prior to any repair or maintenance of the unit in
� order to prevent electric shock or injury.
0
Ensure you do not inhale or consume medication or aerosols from around the unit at the time of
maintenance. These may be harmful to your health.
0
Never splash water directly onto the unit as this may cause electric shock or short circuit.
NI\
Never disassemble, repair, or modify the unit yourself.
W
unauthorized person may result in fire or injury due to a malfunction.
W A R N I N G�]
1
�-\
3
The installation by
If the power supply outlet
ensure that
Any
such work carried out by an