Ac Power Source; Power Consumption; Calibration; Cleaning - BNC 765 Series User Manual

AC Power Source

For External AC Adapter: 100 to 240 VAC (+/-10%) at 45-66 Hz; Automatic AC voltage selection; Installation Category:
300V CAT II
No manual voltage selection is required because the external AC Adapter automatically adapts to line voltage.

Power Consumption

</= 150 watts
WARNING - Electrical Shock Hazard
Only use the power cord provided with your instrument.

Calibration

The recommended calibration interval is one year. Calibration should be performed by qualified personnel only.

Cleaning

Clean only the exterior of the instrument, using a damp, soft cloth. Do not use chemicals or abrasive elements. Under
no circumstances allow moisture to penetrate the instrument.

Abnormal Conditions

Operate the instrument only as intended by the manufacturer.
If you suspect the instrument's protection has been impaired, disconnect the power cord and secure the instrument
against any unintended operation.
The instrument's protection is likely to be impaired if, for example, the instrument shows visible damage or has been
subjected to severe transport stresses.
Proper use of the instrument depends on careful reading of all instructions and labels.
WARNING
Any use of the instrument in a manner not specified by the manufacturer may impair the instrument's safety
protection.
Ver. 2.3
Berkeley Nucleonics Corporation
info@berkeleynucleonics.com | www.berkeleynucleonics.com
2955 Kerner Blvd, San Rafael, CA 94901 | 800-234-7858
Model 765 User Manual
8 of 77