HP 16600A Series User Manual page 137

5 Install the emulation module.
6 Connect the cable and re-install the screws.
7 Reinstall the bottom cover, then turn the frame right-side-up.
8 Plug in the power cord, reconnect the other cables, and turn on
See Also
Chapter 6: Connecting and Configuring the Emulation Module
Installing the Emulation Module
You may connect the cable to either of the two connectors. If you have
two emulation modules, note that many debuggers will work only with
the "first" module: the one toward the top of the frame ("Slot 1"),
plugged into the connector nearest the back of the frame.
the logic analysis system.
The new emulation module will be shown in the system window.
See page 144 for information on giving the emulation module a
"personality" for your target processor.
136 Solutions for CPU32