Table of Contents
Advertisement
The warm air
temperature is not
high enough
The function of warm
Warm air
air is not working
function
properly
The function of
warm air stops
suddenly
The red light of the
button on the product
at one time
The red light of the
button on the product
one time.
The blue light of the
Indicator
button on the product
light and
alarm
one time
function
The red light of the
button on the product
times at one time.
The blue light of the
button on the product
times at one time
The leakage protection
switch on the power
plug often trips.
The remote control
doesn't work
properly
Remote
control
The remote control
button is not
sensitive
Is the warm air temperature set
to a lower state?
Wash function activated.
The user suddenly leaves the
seat; the sensor cannot detect
the correct position.
The water temperature is too
the self-cleaning port constantly.
Seat ring temperature fault .
Water temperature sensor fault.
Seat temperature sensor fault.
The leakage exceeds the normal
value.
Batteries ran out.
The positive and negative
electrodes of batteries set
wrongly.
Batteries power low.
The remote control is too far from
the product or not within the
range of the sensor.
23
Reset the warm air temperature
to a higher state.
then start the warm air function.
Please sit back on the seat and
start the warm air function.
1. Set the water temperature to
supply again.
2.Stop using it when it cannot be
eliminated. Please contact the
service hotline.
Turn on the water inlet and turn
on the power again .
stop using the product. Contact
the service hotline.
Replace new batteries
Set the positive and negative
electrodes of batteries correctly.
Replace new batteries.
Please use the remote control
induction.
Advertisement
Table of Contents
