Table of Contents
Advertisement
5. Install the remote control.
A. Drill two 4.5mm diameter holes with a depth of >20mm in appropriate
positions on the wall according to the position dimensions shown.
B.
the drilled hole.
6. Connect the water
Leakage protection test
(1) Under normal condition, press the "RESET" button on the power plug, the plug indicator
light will be green and the product will start to power on, enter the standby state;
(2)
(3) Press the "RESET" button on the power plug again, the indicator light will be green,
and the power supply of the product will be restored.
C. Secure the remote control
Turn on the tap
Swipe up to remove the remote control.
screws.
7. Switch on the plug
This picture is for
reference only
11
Unit: mm
2- 4.5
D. Battery installation
Indicator
light
Reset
button
Test
button
Advertisement
Table of Contents
