Rockville RCS180-6 Owner's Manual page 8

Functions
(continued)
Remote Control
1. ON/OFF
2. Mode: Select SD, USS, Bluetooth, Optical, or FM radio.
3. Preset EQs: Normal, rock, pop, classic, jazz, and country. 2
4. Mute
5. VOL-/VOL+: Increase or decrease the volume.
6. Play/Pause: Press to play or pause playback. Press to
for two seconds auto-scan and save stations in FM
radio mode.
7. �/►�: Previous/Next song
8. REP: Press once to repeat single track. Press twice to repeat
all tracks. Press three times to repeat all files within a
folder. Press four times to enter random mode.
9. U/SD: Press ot switch between USS and SD input.
10. Number Pad: Select music files by number.
Setup
Selecting Output Wire and Connectors
It is recommended you use high quality 16 AWG, 2 or 4 conductor, heavy gauge, CL2 or
CL3 rated, 100% Oxygen-Free Copper (OFC) speaker wire. CL2 and CL3 ratings refer to
the cable jacket's fire resistance and the voltage capacity of the wire. While both cables
have the same flame resistance capability, the CL2 cable can handle voltage spikes of up
to 150 volts while the CL3 can handle up to 300 volts. When using the 70V/100V speaker
zone output screw connectors, use terminal forks up to 10 AWG (recommended) or bare
wire. Below is a chart to help you select the appropriate size wire based on the amp to
speaker distance.
WIRE SIZE 4OHM LOAD
10AWG 100 FEET
12AWG 60 FEET
14AWG 40 FEET
16AWG 24 FEET
D
CAUTION: Never use shielded
cable for output wiring.
The RCS180-6 features one RCA line output. We recommend you use high quality RCA
cables such as Rockville's RNRTR, RNRMR, or RCDR series.
Selecting Input cables
There are three ¼" balanced TRS mic inputs, one optical input, and one RCA input on the
RCS180-6. We recommend you use high quality Rockville cables like the RCXMB, RCXFB,
or RCTR series ¼" TRS cables and the RNRTR, RNRMR, or RCDR series RCA cbales.
Rack Mounting
This unit should be on the bottom of the rack or above any equipment that does not
produce heat. Be sure to provide at least 1 RU (Rack Unit, 1.75'1 of space above and below.
8
BOHM LOAD 16OHM LOAD
200 FEET 400 FEET
120 FEET 240 FEET
80 FEET 160 FEET
48 FEET 96 FEET
D
CAUTION: For low impedance
loads only.
---
OJww
mmm
0mm
[]]
D
CAUTION: Check local code
requirements before installing
in-ceiling or in-wall speaker wires.
We recommend you use CL2 or
CL3 rated, Oxygen-Free Copper
(OFC) speaker wire.