Before Working Inside Your System; After Working Inside Your System; Remove The Boss-N1 Monolithic Controller - Dell BOSS-N1 User Manual

Before working inside your system

Prerequisites
Follow the safety guidelines listed in
Steps
1. Power off the system and all attached peripherals.
2. Disconnect the system from the electrical outlet, and disconnect the peripherals.
3. If applicable, remove the system from the rack.
For more information, see the Rail Installation Guide relevant to your rail solutions at www.dell.com/poweredgemanuals.
4. Remove the system cover.

After working inside your system

Prerequisites
Follow the safety guidelines listed in
Steps
1. Replace the system cover.
2. If applicable, install the system into the rack.
For more information, see the Rail Installation Guide relevant to your rail solutions at www.dell.com/poweredgemanuals.
3. Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.

Remove the BOSS-N1 Monolithic controller

About this task
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
Steps
1. Press and pull the BOSS-N1 Monolithic filler out from the BOSS-N1 Monolithic controller module bay.
Safety instructions.
Safety instructions.
Install and remove a BOSS-N1 controllers 17