Tadano FAUN ATF 220G-5 Operating, Service And Maintenance Manual page 204

B1-6
6.4.3 Extending the outriggers to the second extension
width
- The position of the outrigger floats has been changed to "crane
operation" (item 6.2.1).
- Remove the lock pins (6) and (9) and insert them in the bore-holes
of the pin holders (7) and (8).
Extend the outrigger beams as described under item 6.1.3.
NOTE The second extension width is reached if both the
outrigger beams have been extended so that the
mark for the second extension width reaches 5.6
m.
Extend all the other outrigger beams analogously in the same way.
Securing the extended outrigger beams at the
second extension width with pins, and
locking them
- Remove lock pins (6) and (9) from the pin
holders, insert them into the bore-holes of the
outrigger casings and of outrigger beam I and
lock them in the grooves of the pin holders (7)
and (8).
Perform outrigger operation and the pin locking
procedure in the same fashion for all the other
outriggers.
14/20
Stabilizing the vehicle by outriggers
0140_EN_FA036_B1_06_00_00_FA029
2003-01