Silvercrest 100550 Operation Instructions Manual page 21

device, you should remove them
immediately in order to prevent
damage to the device!
Avoid contact with the skin, eyes
and mucous membranes. If you
come into contact with corrosive
battery fluids, flush the affected
area thoroughly with clean water
and contact a doctor immediately.
Use
Insert Batteries / Filling of the
salt and pepper mill
Indication: The salt and pepper mill is intended
for peppercorns or coarse salt.
Proceed as follows:
1. Hold the base with the container
turn the top counter­clockwise (see Fig. A)
1
until the arrow on the top
the symbol on the base with container
2. Open the bayonet cap by turning and then
pulling it. The remove the top part
base with container
3. Pull the motor
3
container .
6
4. Insert 6 new batteries type AAA 1.5 V
(LR03).
Indication: Pay attention to the right polarity.
This is shown in the battery compartment.
5. Fill up the base with container
corns or coarse salt. The best result will be
achieved when filling the base with container
up to 75 %.
6. Put the motor back on the base with contai­
3
ner . Be sure to place the notch on the motor
6
marked with a white arrow into the respective
protrusion on the base with container (see Fig.B).
Indication: Please make sure that the con­
tacts , face each other (see fig. A).
4 5
100550_silv_Salz_oder_Pfeffermuehle_Content_ES_IT.indd 21
firmly and
6
is aligned with
1
6
from the
1
.
6
carefully off the base with
with pepper­
6
7. Put the top back on the base with con­
1
tainer .
6
8. Hold the base with container
turn the top clockwise (see Fig. B) until the
1
arrow on the top
on the base with container
Using of the salt
and pepper mill
Pull off the aroma seal cover
tom of the base with container
(see fig. B).
Please keep the switch
the salt and pepper mill. The bulb
base of the salt and pepper mill will then be
simultaneously activated.
Adjusting the grinding level
Turn the adjustable screw
receive a finer grinding level (see fig. C).
Turn the adjustable screw
receive a coarser grinding level (see fig. C).
. Turn the top of the device and press the switch
to remove residues from the grinding mechanism.
Note: Choose a coarser setting if the grinding
mechanism stops rotating when you are using a very
fine setting. If the grinding mechanism still refuses to
rotate, then it may be choked or blocked. Unscrew
the adjustable screw
mechanism. Release the stuck pieces by shaking the
grinding mechanism, then tighten the adjustable
screw again.
8
6
Changing the bulb
Remove the batteries before you change the
bulb . In this way you will ensure that the
9
salt and pepper mill is not turned on by acci­
dent while you are changing the bulb
Note: Use only bulbs of the same type as the
firmly and
6
aligns with the symbol
1
.
6
from the bot­
7
before use
6
pushed to activate
2
on the
9
clockwise to
8
anticlockwise to
8
and loosen the grinding
8
.
9
GB/MT
27.05.14 11:25
2
21