Vega VEGABAR 81 Operating Instructions Manual page 52

7 Set up with the display and adjustment module
Scaling (2)
Current output 1 and 2
(size)
HART mode
Special parameters
Device name
Instrument version
52
In menu item " Scaling (2)" you define the scaling format on the dis-
play and the scaling of the measured level value for 0 % and 100 %.
In menu item " Current output, variable" you specify which measured
variable the current output refers to.
For instruments with SIL qualification, the selection is limited to lin.
percent.
The sensor is preset to the HART mode " Analogue current output".
For instruments with SIL qualification, this parameter cannot be modi-
fied.
The default setting is " Analogue current output" and the address 00.
In this menu item you gain access to the protected area where
you can enter special parameters. In exceptional cases, individual
parameters can be modified in order to adapt the sensor to special
requirements.
Change the settings of the special parameters only after having con-
tacted our service staff.
7.4.5 Info
In this menu item, you can read out the instrument name and the
instrument serial number:
In this menu item, the hardware and software version of the sensor is
displayed.
VEGABAR 81 • 4 ... 20 mA/HART