Commissioning - Triton T70Z Installation And Operating Instructions Manual

Fig.17
Fig.18
T70Z electric shower

COMMISSIONING

Power selector
•
to OFF
•
•
•
Temperature
control set at
Make sure the outlet from the flexible hose is
MINIMUM
directed to waste.
flow setting
1. Before switching on the electric and mains
Turn the
power
selector
2. Turn on the electric and mains water supplies
to COLD
3. Turn the power selector to the COLD setting
4. Slowly turn the temperature control fully
Turn the
temperature
control to the
MAXIMUM
flow setting
5. Once flushing out has been completed turn
6. Fit the shower head to the flexible hose and
7. The shower is now ready for normal operation.
17
Carefully guide the cover onto the backplate
making sure the wires are not trapped.
While applying slight pressure to the front
cover, secure in place using the three
retaining screws.
The first operation of the shower is intended
to flush out any remaining unit debris and
to make sure the heater unit contains water
before the elements are switched on.
This operation must be carried out with
the flexible hose screwed to the outlet but
WITHOUT the shower head attached.
water supplies to the shower, check that the
power selector is in the OFF position and
the temperature control is turned to the
MINIMUM flow position (fig.17).
Note: Failure to turn the control to
MINIMUM FLOW may cause the PRD to
operate.
to the shower.
(fig.18) and wait until water starts to flow
from the flexible hose.
anti-clockwise to the MAXIMUM flow
position (fig.18).
It will take about thirty seconds for a smooth
flow of water to be obtained while air and
any debris is being flushed from the shower.
When there is a smooth flow of water turn
the temperature control steadily from
MAXIMUM to MINIMUM and back again
several times to release any trapped air within
the unit.
the power selector to OFF.
place in the shower head holder.